Disclaimer: This content was generated using AI. While we strive for accuracy, please verify critical information with official sources.
Sources: National Vulnerability Database, CISA KEV, Exploit-DB
CVE-2026-102551 Overview
CVE-2026-102551 affects the IPv6 Router Advertisement (RA) handler in Amazon FreeRTOS-Plus-TCP before version V4.4.2. The handler fails to properly verify the source of incoming RA messages. A remote third party can inject a crafted Router Advertisement to influence an endpoint's IPv6 default gateway, on-link prefix, and address configuration.
The weakness is tracked as [CWE-940: Improper Verification of Source of a Communication Channel]. Amazon addressed the issue in FreeRTOS-Plus-TCP V4.4.2.
Critical Impact
Remote attackers can redirect IPv6 traffic from affected embedded devices, enabling adversary-in-the-middle positioning, traffic interception, and manipulation of host network configuration without authentication.
Affected Products
- Amazon FreeRTOS-Plus-TCP versions before V4.4.2
- Embedded and IoT devices using the FreeRTOS-Plus-TCP IPv6 stack
- Products linking the vulnerable prvProcessICMPRouterAdvertisement code path
Discovery Timeline
- 2026-10-16 - CVE-2026-102551 published to NVD
- 2026-10-19 - Last updated in NVD database
Technical Details for CVE-2026-102551
Vulnerability Analysis
The FreeRTOS-Plus-TCP stack processes IPv6 Router Advertisement messages as part of Stateless Address Autoconfiguration (SLAAC) and default-gateway discovery. The RA handler accepts advertisement contents without adequately verifying that the message originated from a legitimate on-link router.
An unauthenticated attacker on the same broadcast domain, or any party able to deliver traffic to the device's link, can send crafted RAs. The device then applies attacker-controlled values for the default gateway, on-link prefix, and global address configuration. This primitive supports traffic redirection and adversary-in-the-middle scenarios against embedded workloads.
Root Cause
The root cause is improper verification of the communication channel source [CWE-940] in the IPv6 RA processing logic. Standard Neighbor Discovery Protocol (NDP) defenses such as hop-limit checks, link-local source enforcement, and SEND (Secure Neighbor Discovery) validation are either missing or insufficient. As a result, the stack trusts RA parameters that should require stronger origin assurance.
Attack Vector
Exploitation requires the attacker to deliver an IPv6 RA packet reachable by the target. Within a shared Layer 2 segment, any host can emit crafted RAs that the vulnerable device will honor. The attack is network-based and requires no privileges or user interaction, though successful exploitation depends on the attacker's position relative to the target segment.
Technical specifics are available in the GitHub Security Advisory GHSA-pjq5-fqrr-g6pv and the AWS Security Bulletin 2026-139.
Detection Methods for CVE-2026-102551
Indicators of Compromise
- Unexpected IPv6 default gateway changes on embedded or FreeRTOS-based devices.
- Appearance of new on-link IPv6 prefixes advertised by non-approved hosts.
- Device IPv6 global addresses deriving from prefixes not provisioned by network operators.
- RA packets originating from MAC addresses that do not match sanctioned router interfaces.
Detection Strategies
- Monitor ICMPv6 Type 134 (Router Advertisement) traffic and alert on advertisements from unauthorized sources.
- Deploy RA Guard on managed switches to log and block RAs on access ports.
- Correlate SLAAC address changes against an inventory of approved IPv6 routers and prefixes.
Monitoring Recommendations
- Enable NDP and RA logging on upstream routers and L2 fabric.
- Baseline each FreeRTOS device's default gateway and address assignments, then alert on deviations.
- Capture periodic packet samples on IoT VLANs to identify rogue RA sources.
How to Mitigate CVE-2026-102551
Immediate Actions Required
- Upgrade affected firmware to FreeRTOS-Plus-TCP V4.4.2 or later as directed by the vendor.
- Inventory all embedded devices using FreeRTOS-Plus-TCP with IPv6 enabled.
- Enable RA Guard or equivalent L2 filtering on any segment hosting vulnerable devices.
- Restrict IPv6 segments containing affected devices to trusted router infrastructure only.
Patch Information
Amazon released the fix in FreeRTOS Plus TCP Release V4.4.2. Users must upgrade to this version to remediate the issue. Additional guidance is available in AWS Security Bulletin 2026-139.
Workarounds
- Disable IPv6 on FreeRTOS-Plus-TCP devices where the protocol is not required.
- Enforce RA Guard (IETF RFC 6105) on access switches to drop unauthorized RAs.
- Isolate vulnerable devices on dedicated VLANs with strict ingress controls.
- Apply port-level ACLs to block ICMPv6 Type 134 from non-router ports.
# Example: Cisco RA Guard policy to drop RAs on host-facing ports
ipv6 nd raguard policy HOST_PORTS
device-role host
!
interface range GigabitEthernet1/0/1 - 48
ipv6 nd raguard attach-policy HOST_PORTS
Disclaimer: This content was generated using AI. While we strive for accuracy, please verify critical information with official sources.
Sources: National Vulnerability Database, CISA KEV, Exploit-DB

